Inovance HD380-5T0.7GB, User Manual

Page: 81 / 298

Function Code Table
MD380 User Manual
- 80 -
Chapter 5 F unction Code Table
If FP-00 is set to a non-zero number, parameter protection is enabled. You must enter the
correct user password to enter the menu.
To cancel the password protection function, enter with password and set FP-00 to 0.
Group F and Group A are standard function parameters. Group U includes the monitoring
function parameters.
The symbols in the function code table are described as follows:
"
☆
": The parameter can be modi fi ed when the AC drive is in either stop or running state.
"
★
": The parameter cannot be modified when the AC drive is in the running state.
"●": The parameter is the actually measured value and cannot be modified.
"*": The parameter is factory parameter and can be set only by the manufacturer.
5.1 Standard F unction Parameters
F unction
Code
Parameter Name Setting Range Default Property
Group F 0: Standard F unction Parameters
F 0-00 G/P type display
1: G type (constant torque load)
2: P type (variable torque load
e.g. fan and pump)
Model
dependent
●
F 0-01 Motor 1 control mode
0: Sensorless fl ux vector control
(S F VC)
1: Closed-loop vector control
(CLVC)
2: Voltage/
F requency (V/ F )
control
0
★
F 0-02 Command source selection
0: Operation panel control (LED off)
1: Terminal control (LED on)
2: Communication control (LED
blinking)
0
☆
F 0-03 Main frequency source X
selection
0: Digital setting (non-retentive at
power failure)
1: Digital setting (retentive at
power failure)
2: AI1
3: AI2
4: AI3
0
★