Page 7
EN
Chapter 2 Safety
HIGH
PRESSURE
!
DANGER
Observe the following in-
structions for safe handling of the ma-
chine:
1. Only use the inoBEAM F30 “HP” with a
mortar pressure gauge.
2. Only use labelled high-pressure hoses
with at least 120 bar operating pressure.
HIGH
PRESSURE
The high-pressure variant
inoBEAM F30 “HP”
is NOT designed to be used as a cleaning
device.
2.2 General risk sources
!
DANGER
Electrical voltage.
Danger of death due to electric shock.
• Work on the electronic control system may only be per-
formed by a qualified electrician.
• Switch off the machine and pull out the mains plug.
• Secure the machine against unexpectedly being switched
back on.
• Only connect the pump to regulation construction site
power distribution points with type B FI circuit breakers
(30 mA).
• The connection must be fused with 16 A.
• The cross-section of the supply cable is at least 2.5 mm
2
at 230 V 1 PH.
• Connect the supply cable to the 230 V / 16A “feed
supply” CEE plug.
• All operating equipment on the construction site must
generally be connected according to BGI/GUV-I 608.
!
DANGER
Rotating shafts.
Danger of death due to being pulled into the ma-
chine and crushed.
When the motor is running, the pump shaft rotates
in the material hopper!
• Do not reach into the rotating shaft.
• Do not place any objects into the rotating shaft.
1. Before working on the pump shaft, interrupt the external
power supply. Loosen the screws of the protective screen
above the material hopper only when the machine is
switched off.
2. To do this, press the red push button on the switching
cabinet.
3. Pull out the mains plug.
4. Secure the machine against unexpectedly being switched
back on.
!
DANGER
Pressurised conveyor hoses.
Risk of injury and risk of property damage due to
escaping and/or flying material, and/or bursting
conveyor hoses!
• Before disconnecting the conveyor hoses, make sure that
the hoses are depressurised. To do so, check the pressure
indicator on the mortar pressure gauge. The pressure in-
dicator must display 0 bar!
• Before opening the hose coupling, let the inoBEAM F30
run in reverse to reduce any pressure!
• Use only conveyor hoses which, depending on the set
used, are permissible with an operating pressure of 40
bar (set “D” and “R”) or 230 bar (set “HP”), and are in
technically perfect condition (e.g. do not have any cracks
or other external damage!).
HIGH
PRESSURE
!
DANGER
Using the high-pressure hose.
• Check the high-pressure hose before
each use and replace any damaged hoses
immediately.
• Never repair defective high-pressure
hoses yourself.
• Avoid severely bending or kinking the
high-pressure hose (smallest bending
radius approx. 20 cm)
• Never pull on the high-pressure hose to
move the machine.
• Never clean high-pressure hoses with sol-
vents.
• Lay the high-pressure hose so that there
is no risk of tripping and make sure that
no one drives over the high-pressure
hose.
