Page 31
EN
Chapter 7 Operation, use
7 Operation, use
7.1 Safety during operation
!
DANGER
Electrical voltage.
Danger of death due to electric shock.
• Work on the electronic control system may only be per-
formed by a qualified electrician.
• Switch off the machine and pull out the mains plug.
• Secure the machine against unexpectedly being switched
back on.
!
DANGER
Rotating shafts.
Danger of death due to being pulled into the ma-
chine and crushed.
When the motor is running, the pump shaft rotates
in the material hopper!
• Do not reach into the rotating shaft.
• Do not place any objects into the rotating shaft.
!
DANGER
Pressurised conveyor hoses.
Risk of injury and risk of property damage due to
escaping and/or flying material, and/or bursting
conveyor hoses!
• Before disconnecting the conveyor hoses, make sure that
the hoses are depressurised. To do so, check the pressure
indicator on the mortar pressure gauge. The pressure in-
dicator must display 0 bar!
• Before opening the hose coupling, let the inoBEAM F30
run in reverse to reduce any pressure!
• Use only conveyor hoses which, depending on the set
used, are permissible with an operating pressure of 40
bar (set “D” and “R”) or 230 bar (set “HP”), and are in
technically perfect condition (e.g. do not have any cracks
or other external damage!).
7.2 Activities before use
7.2.1 Preparing the machine (pump set “D” and “R”)
1. Connect the mortar hose with the quick-release cou-
pling to the hose connection of the mortar pressure
gauge by closing both cam levers.
2. Fill approx. 2 to 3 litres of lime milk or wallpaper paste
into the material hopper as pre-lubrication.
3. Switch on the machine by pressing the main switch
(green button).
4. Switch on the pump by turning the switch to “Start”
and allow the pre-lubrication to flow from the material
hose into a bucket or suitable container. Ensure that the
pump does not run dry, otherwise the service life of the
rotor/stator will be shortened.
5. Switch the pump off by turning the switch to “0”.
6. If necessary, extend the mortar hose and air hose to the
desired delivery range.
7. Assemble the appropriate spray head or a one-handed
gun to the end of the mortar hose and connect the air
hose to the spray head.
8. Fill the material hopper with the paste-like material to
be processed.
9. Switch off the machine by pressing the main switch
(red button).
Functionality with remote control cable
10. Take the dummy plug out of jack for the remote con-
trol cable and insert the remote control cable into the
contact.
11. Connect the remote control cable to the material hose
and the air hose of the compressor using adhesive tape
or cable ties.
7.2.2 Preparing the machine (pump set “HP”)
HIGH
PRESSURE
1. Connect the high-pressure hose to the
screw connection on the hose connec-
tion of the mortar pressure gauge and
tighten it firmly.
2. Then attach the spray gun to the other
end of the hose with the screw connec-
tion and tighten it firmly.
3. Connect the green control cable of the
mortar pressure gauge to the remote
control connector on the machine's
switching cabinet. (The pressure control
is factory-set and automatically switches
the pump off when it reaches 90 bar or
on again when it falls below 75 bar).
4. Fill the material hopper with the paste-
like material to be processed.
