Page 34
EN
Chapter 8 Areas of application
7.3.6 Checking operating performance
1. If you notice any deviations in the operating behaviour,
decommission the inoBEAM F30 immediately.
2. Ensure that the damage and/or defects which led to the
deviating operating behaviour are rectified.
7.3.7 Topping up material
The inoBEAM F30 can be fed with a pre-made paste-like
material from buckets or using an upstream continuous
mixer, e.g. an inoMIX S16 or S50. In both cases, ensure that
there is always a sufficient amount of pumpable material in
the pump hopper!
!
WARNING
Operation without any material or with
too little material.
Danger of destroying the rotor/stator.
If the machine is operated without any material or with too
little material, there is a risk of the rotor/stator being de-
stroyed within an extremely short period of time (< 1 min.)!
7.3.8 Changing material
Before changing material, clean the inoBEAM F30 and all
the accessories.
7.3.9 Change of location on the construction site
The inoBEAM F30 is equipped with two wheels, two swivel
castors and an extended handle on the frame. The inoBEAM
can, therefore, be moved on the construction site conveniently.
!
CAUTION
Changing location can put the safety of
operating staff at risk and impair the functionality of
the machine.
1. Switch off the machine and pull out the mains plug.
2. Always install the machine in such a way that it is level
and stable.
3. Secure the machine against undesirable movements.
4. Reconnect the machine to the external power supply
before restarting the machine.
7.3.10 Work break/end of work
If the duration of a work break exceeds the setting time of
the material to be processed, there is a risk of the material
setting during the break (observe the ambient tempera-
ture).
HIGH
PRESSURE
1. Whenever spraying is interrupted, release
the trigger and secure the spray gun.
2. Switch the machine off.
3. Release the residual pressure from the
gun until the pressure indicator on the
pressure gauge shows zero bar.
7.3.11 Cleaning the machine
1. Run the inoBEAM F30 and accessories used (e.g. ma-
terial conveyor hoses) until they are empty.
2. Switch off the delivery pump and pull out the mains
plug.
3. Clean the machine and accessories.
