Page 26
EN
Chapter 4 Assembly and function
4.7.4.4 Assembly: Pressure flange with check valve
1. Insert the paint strainer in
the centre piece. Then place
the centre piece on the pres-
sure flange with the check
valve.
2. Insert the copper gasket
into the outlet flange and
place it on the centre piece.
4. Screw the pressure sensor
onto the pressure gauge re-
ceptacle.
3. Insert the three screws
(M10 x 120)...
... and tighten with 60 Nm.
5. Slide the housing over the
pressure sensor.
... and connect it to the
housing bracket on the out-
let flange with two screws
(M6 x 20)
Pump unit “HP” ready mounted
