96-06434-00-01 revA
Service Manual, Inogen One G3HF
-100-
Figure 6: Torque the screws to 6 in-lbs.
2. Add the washers and reinstall the two screws connecting the filter body to the
compressor, lightly tightening by hand (Figure 7). Place two screws on the filter body
to the chassis (Figure 5). Torque these screws to 10 in-lbs.
Figure 7: Torque the screws to 10 in-lbs.
3. Replace the filter and the four screws that attach it to the filter body (Figure 2).
4. Replace the two screws attaching the Filter Body to the Chassis (Figure 4.) Torque to 6 in-
lbs.
4. Insert the Tube Bracket pegs into the slots in the chassis (Figure 3). Replace the two
screws holding in the Tube Bracket and Muffler Assembly. Torque to 4 in-lbs.
4. Make sure the other end of the filter body tubing is oriented in its designated space on the
tube bracket (Figure 3).
5. Replace the bottom center screw on the motherboard that attaches the filter body to the
motherboard (Figure 1). Tighten screw to 4.5 in-lbs.
Washers
3
2
1
4
