Ingersoll-Rand ReliaTel, Manual, Page: 98 / 176

98 RT-SVD03L-EN
BAYSENS016* Sensor with plug;
Thermistor Sensor (OAS, SAS, RAS,
CTS)
O Ou uttd do oo orr A Aiirr S Se en nsso orr: Located in the condenser
section, lower left corner. The compressor access panel
has a slotted opening to provide airflow across the
sensor. Standard with all ReliaTel™ controlled units.
R Re ettu urrn n A Aiirr S Se en nsso orr: Field or factory installed accessory.
Located on the return air damper of the economizer,
used with comparative enthalpy control only.
C Co oiill T Te em mp pe erra attu urre e S Se en nsso orr: Located in a 3/8" copper
tube well, which is brazed to the lowest circuit entering
the outdoor coil (2 to 10 tons - heat pumps only).
M Miix xe ed d A Aiirr S Se en nsso orr:: Field or factory installed in the
supply fan section, protruding through the fan housing.
D Diisscch ha arrg ge e A Aiirr S Se en nsso orr:: Field or factory installed in the
supply fan section, using an averaging tube located
downstream of the heat section.
Figure 51. Thermistor sensor
BAYSENS106*/ASYSTAT106*
N No otte e:: Part number SENS01515
Accessory Heat / Cool Zone Sensor Module (ZSM)
single set point, manual changeover. Four conductors
required.
Figure 52. BAYSENS106*/ASYSTAT106*
2
4
Calibration
Pot 1 (see
) Note 1
Note 1:
Pot 1 is
factory
calibrated.
Field
adjustment
voids
warranty. 3
R6, 8.45 k
W
R1, 4.87 k
W
R2, 2.32 k
W
R3, 19.6 k
W
Heat
Off
Cool
RT1 thermistor,
10 k
at 25°C
W
1
R11, zero
W
Signal common
Cool setpoint (CSP)
Mode
(Sys/Fan switch)
Zone
temperature
TB1
Auto
On
Temperature
setpoint
Pot 5,
1 k
W
System
SW1
Fan
SW2
Dwg source: X39641086-01
BAYSENS107*/ASYSTAT107*
N No otte e:: Part Number - SEN01528
Accessory Heat Pump Zone Sensor Module (ZSM)
single set point, manual changeover. Six conductors
required.
T Th he errm mo osstta attss a an nd d S Se en nsso orrss