InfoPrint 6500 DBCS, User Manual

Page: 140 / 230

140
Chapter 6
Fault Messages
045 FIRMWARE ERROR*
SEE USERS MANUAL
No Application software
tried to perform an illegal
printer function or
damaged memory is
detected on the
controller board. Contact your InfoPrint
service representative.
046 EC STOPPED AT
STATE
<state>
No Controller self–test and
initialization sequence
was halted at <state>,
where <state> is one of
10 numerically coded
messages. Contact your InfoPrint
service representative.
051 HAMMER SHORT*
SEE USERS MANUAL
No Hammer driver circuits
on the controller board
shorted to ground. Contact your InfoPrint
service representative.
052 MECH DRIVER HOT
SEE USERS MANUAL
No Mechanism driver
temperature is elevated
beyond normal
threshold. Contact your InfoPrint
service representative.
053 48 VOLTS FAILED*
RECYCLE POWER
No The power supply is not
generating a proper 48
volts or the CMX board
is not properly detecting
a 48 volt output. Contact your InfoPrint
service representative.
054 HAMMER COIL
SHORT*
SEE USERS MANUAL
No Hammer coil shorted to
ground. Contact your InfoPrint
service representative.
055 MECH. DRIVER LINK
FAILURE
SEE USERS MANUAL
No Link failure between the
the controller board and
mechanism driver board. Contact your InfoPrint
service representative.
056 HAMMER COIL CHECK
SEE USERS MANUAL
No Hammer coil open. Contact your InfoPrint
service representative.
057 CLOSE PLATEN Yes Platen lever is raised to
the open position. Lower the platen lever.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution