InfoPrint 6500 DBCS, User Manual

Page: 170 / 230

170
Chapter 6
Fault Messages
H/B CONTROL MODE
SEE USERS MANUAL
N/A A status message
indicating that one or
more hammer coils are
hotter than normal and
the printer will run in
half–speed mode until
they cool down. This can
occur during especially
dense print jobs. None required. The
printer automatically
corrects the condition by
running at half–speed
mode until the hammers
cool down, at which point
it resumes full speed
printing.
HMR BANK NOT
INSTALLED
SEE USERS MANUAL
No Hammer bank is not
installed. Contact your InfoPrint
service representative.
HAMMER COIL BAD
#, #, #, #,...etc.
No Hammer coil(s) number
#, #, etc. failed the
current test at power-up. (You can continue to print
with degraded print
quality.) Contact your
InfoPrint service
representative.
ILL INST ACCSS* Yes Illegal Instruction
Access:a firmware error
on teh controller board. Cycle power. Run the
print job again. If the
message appears,
download the emulation
software again. If the
message appears,
contact your InfoPrint
service representative.
INCOMPAT E-NET Yes Incompatible ethernet
interface card is
installed. Install a compatible
ethernet interface card to
the printer then reboot. If
this message still
appears, contact your
InfoPrint service
representative.
INTAKE FAN FAULT Yes Sensors cannot detect
current in fan circuit. See description for HMR
BANK FAN FLT.
INTERRUPT UNUSED
VECTOR 00 No The controller board
receives an interrupt it
does not understand. Cycle power. If this
message occurred once
and never again, you can
ignore it. If the message
reappears or appears
consistently, contact your
InfoPrint service
representative.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution