Infinova V2923ACN Series, Installation & Operation Instructions

Page: 35 / 56

29
Item Function
H
MON TITLE
LCK
Either locks or unlocks the on-screen Camera Number and Monitor Status.
Options

LOCKED = to set the on-screen Camera Number and Monitor Status into a locked state.

UNLOCKED = to allow the on-screen Camera Number and Monitor Status to be updated
with each event.
Use the ACK key to select.
Item Function
I
DISPLAY
STATUS
Sets the display status for the monitor when a tour is selected for the monitor. (See Item
D
.)
Options

RUN = to run the selected tour.

HOLD = to hold the switched camera on the monitor.
Use the ACK key to select.
5.4.2 Set Monitor Function
1 ATTRIBUTE
2 FUNCTION
3 STATUS
MONITOR
RETURN MAIN
SET FUNCTION
ENT MON USE KEYG CAMG
001 001:001 MON ALL ALL
002 002:002 MON ALL ALL
003 003:003 MON ALL ALL
004 004:004 MON ALL ALL
005 005:005 MON ALL ALL
006 006:006 MON ALL ALL
007 007:007 MON ALL ALL
008 008:008 MON ALL ALL
PREVIOUS MENU
The SET FUNCTION menu can define the use of the monitor:
MON, CHL, CCH, or disabled.
Select the FUNCTION menu from the MONITOR menu to enter
the SET FUNCTION page. A single menu screen displays
information for 8 monitors. Use the CLOSE/OPEN key to page
down or up. The menu screen displays the following information of
monitors:
Note: the menu is not available for non-host matrix switcher.
SET FUNCTION
ENT MON USE KEYG CAMG
001 001:001 MON ALL ALL
A B C D
E
Item Function
A
ENT
Sequence number.
B
MON
The number of the monitor under setup.
The number before “:” indicates the number of the site where the monitor locates; and the
number behind “:” indicates the number of the monitor.
For example, “001:001” indicates monitor 1 locates at site 1.
C
USE
Define the use of the current monitor. Four options are provided: “MON”, “CHL”, “CCH”
and “---”, which indicates monitor, channel, channel for networking with matrix switchers
with V300 series firmware or V2060 series matrix switchers and disabled respectively.
D
KEYG
Set a keyboard group for the monitor.
Only the keyboards in the selected keyboard group can control the respective monitor. The
setting here is the same as the KEYBOARD GROUP in menu 2.1 ATTRIBUTE, and they are
interacted with each other.
E
CAMG
Set a camera group for the monitor.
Only the cameras in the selected camera group can display on the respective monitor. The
setting here is the same as the CAM GROUP in menu 2.1 ATTRIBUTE, and they are
interacted with each other.
NOTE:
1. The functions of the monitors at non-host matrix switchers
should be configured at menu 2.2 FUNCTION at the host matrix
switcher.
2. If a monitor is armed, the monitor will be disarmed (that is DIS)
when the monitor’s function is set to “CHL” or “CCH” (e.g.
channel).