18
8. Rolls
Note: If roll configuration is different than shown, see addendum
Figure 18: Rolls
a)
Removal
•
Disconnect
the
power cord
from the machine.
1. Remove the all drive train components. (See Section: 2)
2. Remove the
fold trays
, simply lift up trays and slide out of chassis.
3. Remove the
feed gauge x-tie mounting screws
from the drive train side of the chassis. (See Figure 19)
4. Remove the
feed table mounting screws
from the drive train side of the chassis. (See Figure 19)
5. Remove the
feed roller mounting screws
from the drive train side of the chassis. (See Figure 19)
6. Remove the
conveyor table mounting
screws
from the drive train side of the
chassis. (See Figure 19)
7. Remove the
nip wheel x-tie mounting
screw
from the drive train side of the chassis.
(See Figure 19)
8. Remove the
drive motor guards
and the
drive motor
mounting screws. The drive
motor can be left in the machine.
9. Ensure the
electrical side cover
is in place
and on a sturdy surface tip the machine so
that the electrical side is face down. Ensure
the drive motor is securely resting and no
wires are being pinched or stretched.
10. Remove the
base plate mounting screws
and
rear leg
from the drive train side frame.
11. Slide the
drive train side frame
off of the
rolls and remove.
SERVICING THE ROLLS
Summary of Contents for 7K Plus
