14
4. Feed Gauge
Figure 11: Feed Gauge Assembly
a)
Removal
•
Disconnect the power cord from the machine.
1. Remove the
feed gauge cover
.
2. Remove both
side covers
.
3. Remove the
x-tie screws
from both side frames.
(See Figure 19)
4. Pull the
feed gauge assembly
up and out of the
machine.
Note:
If the
x-Tie
is too tight in the chassis to remove it
maybe necessary to loosen the
feed table
,
feed idler
shafts
,
conveyor
,
sensor x-tie
, and
front & rear
motor guard screws
on the
motor side frame
. (See
Figure 19)
b)
Installation
1. Assembly is the reverse of the removal.
2. Adjust the
feed gauge
.
c)
Adjustment
•
Disconnect
the
power cord
from the machine.
1. Remove
feed gauge cover
2. Place 1 form on the feed table and hand feed the form into the machine by moving the feed belt with your
hand.
3. Pull the paper out of the machine. You should feel resistance, but not too much. Turn the
adjustment screw
clockwise for less resistance and counter-clockwise for more resistance.
Figure 12: Cross-section of Feed Gauge
Adjustment Screw
Summary of Contents for 7K Plus
