Infinity Solutions 7K Plus, Service Manual

Page: 45 / 52

45
Sealer Rollers
20
22
21
37
38
2 19
ITEM PartNo DESCRIPTION
Rolls
Config/
QTY.
2 25-0377-00 Hardened Race 8
19 70-0087-00 Urethane Feed Roll 1
20 70-0088-00 Feed Drive Roll 1
21 70-0089-00 Hex End Roll 1
22 70-0090-00 Conveyor Drive Roll 1
37
82-0145-00
0.060" Delrin Thrush Washer 6
38 82-0479-00 0.100" Delrin Thrush Washer 2
Bri-Lin Corporation
16 Amarosa Drive
Rochester, NH 03868
B
L
DRAWING TITLE
CHASSIS
PART #
REVISION DRAWN BY
DRAWING # SCALE DRAWING DATE
18-0192-00
MD-0192-00
7/25/2005
MATERIAL
FINISH
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN INCHES
TOLERANCES:
ANGLES 1
1 PLACE DECIMALS .05
2 PLACE DECIMALS .010
3 PLACE DECIMALS .005
4 PLACE DECIMALS .0005
1:3
THIS DOCUMENT AND THE DATA DISCLOSED HERIN OR
HEREWITH IS NOT TO BE REPRODUCED, USED OR DISC-
LOSED IN WHOLE OR IN PART TO ANYONE WITHOUT THE
PERMISSION OF BRI-LIN CORPORATION
SHEET 3 OF 3
Rolls
a) Removal
•
Disconnect the power cord from the machine.
1. Remove the all drive train components. (See Section: 2)
2. Remove the fold trays , simply lift up trays and slide out of chassis.
3. Remove the feed gauge x-tie mounting screws from the drive train
side of the chassis. (See Figure 19)
4. Remove the feed table mounting screws from the drive train side of
the chassis. (See Figure 19)
5. Remove the feed roller mounting screws from the drive train side
of the chassis. (See Figure 19)
6. Remove the conveyor table mounting screws from the drive train
side of the chassis. (See Figure 19)
7. Remove the nip wheel x-tie mounting screw from the drive train
side of the chassis. (See Figure 19)
8. Remove the counter sensor x-tie mounting screw from the drive
train side of the chassis. (See Figure 19)
9. Remove the drive motor guards and the drive motor mounting screws. The drive motor can be left in the
machine.
10. Ensure the electrical side cover is in place and on a sturdy surface tip the machine so that the electrical side
is face down. Ensure the drive motor is securely resting and no wires are being pinched or stretched.
11. Remove the base plate mounting screws and rear leg from the drive train side frame.
12. Slide the drive train side frame off of the rolls and remove.
Figure 34: Rolls