Infinity Solutions 7K Plus, Service Manual

Page: 24 / 52

24
5. Remove the reflective sensor from the bracket. Figure 24: Sensor Location
b) Installation
1. Installation is the reverse of removal.
2. Test.
10. Troubleshooting
10.1. Machine Will Not Power On
1. Check that the power switch / breaker is in the “on” position. (when in the “on” position it will
be lit up red)
2. Check that the power cord is properly connected to the machine.
3. Confirm the following components are not faulty in the proceeding order:
a) Wall socket
b) Power cord: test by switching it with a known working power cord. The machine
utilized a standard IEC computer power cord.
c) Power switch / breaker: If the power switch will not light up, wait a few minutes and
try again. If it will still not work, replace the switch. If the power switch / breaker
comes on but only stays on for short periods of time, replace the switch.
d) Electrical connections:
(a) Disconnect the power cord from the machine.
(b) Remove electrical side cover .
(c) Refer to the wiring schematic and check all electrical connections.
e) Power Supply (See Section: 10.7.2)
f) PLC (See Section: 10.7.3 )
g) If the above steps have been followed and the machine will still not power on please
contact Infinity Solutions Manufacturing.
10.2. Machine Powers On But Will Not Run
1. Ensure the drive train cover is in place and the safety switch is engaged.
• Disconnect the power cord from the machine
2. Open the access panel on the drive train cover. With a 7/16 socket turn over the hex end shaft
and attempt to rotate, if there is heavy resistance or it is locked proceed with the following
steps. If it will rotate with minimal resistance go to step 3.
a) Check for a paper jam. (See Section: 10.4)
b) Inspect for any foreign objects in the
rolls .
c) Remove the drive train cover and inspect drive train components for faulty
components.
i) If all components appear to be in acceptable condition remove the drive motor belt and attempt to
rotate the hex shaft again. If this solves the problem test the drive motor . (See Section: 10.7.5)
ii) If the problem persists with the drive motor belt removed, repeat steps (a), (b), and (c) to ensure they
are not the issue. If no solution is found continue removing components until the problem is isolated.
3. Minimal resistance when rotation the shaft.
a) Ensure the drive train cover is in place and the safety switch is engaged.
i) If a bad switch is suspected, test for continuity with a multi-meter.
b) Check proper operation of the. (See Section: 9.6 )
c) Check proper operation of the
reflective sensor . (See Section: 9.7 )
d) Check proper operation of the electrical components in the following order. (See
Section: 10.7)
1. Touch Screen