Infinity Solutions 7K Plus, Service Manual

Page: 43 / 52

43
c) Adjustments
1. With the idler bracket loose, slide the idler wheel and bracket up until the belt is tight. Tension the belt so
that the belt and gears move freely with minimal resistance. If the belt is too loose excess noise and
premature belt failure can occur
Feed Gauge
7
8
1
2
3
5
6
4
9
ITEM PartNo DESCRIPTION QTY.
1 70-0066-00 Sprung Feed Guage X-Tie 1
2 70-0067-00 Sprung Feed Guage Roll 1
3 80-0407-00 Feed Guage Slide Pin 2
4
49-0044-00
Feed Guage Clear O-Ring 12
5
84-0385-00
Feed Retard Spring 2
6 84-0164-00 Black #10-32 Thumb Screw 2
7 80-0369-00 Adjustment Screw 1
8 70-0080-00 Feed Guage Cover 1
9 80-0156-00 FHSCS #10-32 x 1" 4
.010
3 PLACE DECIMALS .005
Rochester, NH 03868
B
L
DRAWING TITLE
16 Amarosa Drive
LARGE MACHINE
PART # REVISION DRAWN BY
DRAWING # SCALE DRAWING DATE
18-0014-00
MD-0014-00 A
1/18/2005
AAS
MATERIAL
FINISH
FEED GUAGE ASSY
Bri-Lin Corporation
4 PLACE DECIMALS
1:2
.0005
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN INCHES
TOLERANCES:
ANGLES 1
1 PLACE DECIMALS .05
2 PLACE DECIMALS
THIS DOCUMENT AND THE DATA DISCLOSED HERIN OR
HEREWITH IS NOT TO BE REPRODUCED, USED OR DISC-
LOSED IN WHOLE OR IN PART TO ANYONE WITHOUT THE
PERMISSION OF BRI-LIN CORPORATION
a) Removal
•
Disconnect the power cord from the machine.
1. Remove the feed gauge cover .
2. Remove both side covers .
3. Remove the x-tie screws from both side frames.
4. Pull the feed gauge assembly up and out of the
machine.
Note: If the x-Tie is too tight in the chassis to remove it maybe
necessary to loosen the feed table , feed idler shafts ,
conveyor , sensor x-tie , and front & rear motor guard
screws on the motor side frame .
b) Installation
1. Assembly is the reverse of the removal.
2. Adjust the feed gauge .
Cross-section of Feed Gauge
Paper
Form
Adjustment Screw