36
Table 4.1 Customer-supplied equipment and services
Item
Purpose
Restrictions
a
Note:
The kit includes a label that replicates important
information that appears on the back of the RGX,
including the unit’s LAN MAC and WAN MAC values.
These two values are to be customer recorded onto the
kit label in the provided areas. Ensure the values are
recorded on the kit label and the label has been customer
affixed to an area of the RGX that will be visible during
operation.
Magnet Mount Kit from
Industrial Scientific
For use with metal surface
mounting
Do not
use with units that will draw power from a fixed DC
power source.
See the
Service
section of this "Product Manual" for
instruction.
Power source, external (optional)
Fixed DC power source
Operational power suitable for
permanent installations.
9–30
VDC with a maximum current of 5A.
Hubs and conduits suitable for the application and hole
size 27.8 mm (1.094
″
).
ISERTPS
b
from Industrial
Scientific
Operational power suitable for
extended run-time
installations.
Before using the ISERTPS, ensure your application
meets the product's certified uses and restrictions: read
and understand the ISERTPS
Product Manual (
part
number 17158248).
ERTPS
b
from Industrial
Scientific
Operational power suitable for
extended run-time
installations.
Before using the ERTPS, ensure it suits your application:
read and understand its
Product Manual
(part number
17158385).
Note:
Except for its IS cable, the ERTPS is
not
certified for use in any hazardous-classified areas.
Supplies (optional)
Torx screwdriver set with T20,
T25, and T30 bits
For use with removal and
installation of conduit-hub
plugs (T20 screwdriver and
3/8
″
open-end wrench), wall
mounts (T30), and case
fasteners (T25)
Suitable for the installation location.
3/8
″
open-end wrench
Other (optional)
Ethernet cable for operation (if
needed, 90° adapter or short
adapter cable)
Required only for units that
will use Ethernet during
operation.
10/100 Ethernet support using an Ethernet cable that
comprises RJ45 connectors and is of the cable type Cat5
or greater. For longer cables, 14
−
110 m [46–360 '], use a
solid conductor shielded twisted pair cable. To prevent
damage to the Ethernet cable and the RGX, it is
recommended that the Ethernet cable have either no
strain relief or flexible strain relief; if needed, a 90°
adapter or short adapter cable may be used.
Document Number: 0000037533
DO NOT CHANGE WITHOUT THE FOLLOWING AGENCY APPROVALS(S):N/A
Modified: 2018-05-25 13:18:14 EDT
State:In Work
INDUSTRIAL SCIENTIFIC CORPORATION
Title: PRODUCT MANUAL RGX GATEWAY-EN-1
Eng:
Drawing No: 17158071-1
Drawn By: Gaygan, Nancy
Created: 2018-05-16 10:24:51 EDT
Rev: 1
Printed By: Kuzmich, Bob
Int: 1.5
Date:May 29, 2018
