29
Figure 3.4
1
Shut down the RGX
Set the unit on the work surface, case lid facing up.
Observe the power-button light.
x
If the light is
off,
continue.
x
If the light is on and
green
only (blinking or solid),
shut down the
unit
. Press the power button for approximately 7 seconds; when its
light starts blinking, release the button. The power-button light will
blink red and green to indicate shutdown is in progress; it will turn
off to indicate the unit is fully shutdown.
x
If the light is on and includes
red
light (blinking or solid),
see
Table
3.6
before continuing
.
2
Access unit interior
Using a torx screwdriver with a T25 bit, unscrew and remove the four
screws that secure the case lid to the case base.
Set aside the screws for later reinstallation.
The case is hinged on the left; open its lid from right to left.
3
Connect Ethernet cable; power on unit
Before connecting the Ethernet cable, you will need to ensure the
computer and the RGX are on the same network. Consult your network
administrator for assistance.
Note:
For network connections, the RGX
default static IP is 192.168.1.1.
Next, connect one end of the customer-supplied Ethernet cable Cat5 or
greater to the computer, then connect the other end to the RGX Ethernet
port.
Power on the RGX: On the case lid, press the power button for
approximately 5 seconds. Observe the power-button light and proceed
as noted below.
Green only
(blinking or solid)
Continue.
Includes red
(blinking or solid)
See
Table 3.6
before continuing
.
Light does not turn on
Try again; be sure to hold the power
button for a full 5-second count. If
the condition persists, the unit may
not have sufficient charge. Charge
the unit before continuing.
4
Observe RGX interior LEDs
Observe the interior LEDs located near the left edge of the PCB (printed
circuit board). From top to bottom, they are labeled COMM STAT, LENS
STAT, ERR2, and ERR1. Each light may be on or off.
Check the ERR2 light (third from top). At this point, it may be red;
continue.
Document Number: 0000037533
DO NOT CHANGE WITHOUT THE FOLLOWING AGENCY APPROVALS(S):N/A
Modified: 2018-05-25 13:18:14 EDT
State:In Work
INDUSTRIAL SCIENTIFIC CORPORATION
Title: PRODUCT MANUAL RGX GATEWAY-EN-1
Eng:
Drawing No: 17158071-1
Drawn By: Gaygan, Nancy
Created: 2018-05-16 10:24:51 EDT
Rev: 1
Printed By: Kuzmich, Bob
Int: 1.5
Date:May 29, 2018