Chapter 4
4
Installation and Operation
Introduction
Site Selection
Placement and Mounting
Installation Preparation
Installation
Operation Precheck
Introduction
Only qualified personnel should install and operate the RGX™ Gateway.
To help prevent injury and damage to the equipment, handle the unit with care and avoid dropping it.
NOTICE:
A customer's intended use of the RGX Gateway may require mounting, as well as the installation
of a compatible fixed DC power source, an Ethernet connection, or both. These and other tasks will require
the customer acquisition and use of equipment, tools, and services. All customer-supplied equipment, tools,
and services required to install (or uninstall), mount, or otherwise secure (or remove) the unit must comply
with and be used in ways that meet any restrictions imposed by the hazardous-classified area; local, state,
or national codes, regulations, standards, permits, or other requirements; and the Authority Having
Jurisdiction (AHJ). The wiring of intrinsically safe circuits
typically
follows these examples.
x
NFPA 70 National Electric Code (NEC); Article 504
x
CSA C22.1 Canadian Electric Code (CEC); Appendix J 18-152
x
IEC/EN 60079-14 Electrical installations
A list of possible customer-supplied equipment items and services is provided below.
Table 4.1 Customer-supplied equipment and services
Item
Purpose
Restrictions
a
Mounting (optional)
Mounting surface and
mounting equipment items
Mounting the unit for
operation.
The mounting surface must support 10.9 kg (24 lb) static
weight, and must meet any weight-bearing requirements
of the customer-supplied mounting equipment.
A strut-type kit or strut-type rails and fasteners for
mounting are suitable for a permanent installation. A unit
can also be surface mounted.
Wall Mount Kit from Industrial
Scientific
For use with surface mounting
or strut-type mounting
See the
Service
section of this "Product Manual" for
instruction.
Document Number: 0000037533
DO NOT CHANGE WITHOUT THE FOLLOWING AGENCY APPROVALS(S):N/A
Modified: 2018-05-25 13:18:14 EDT
State:In Work
INDUSTRIAL SCIENTIFIC CORPORATION
Title: PRODUCT MANUAL RGX GATEWAY-EN-1
Eng:
Drawing No: 17158071-1
Drawn By: Gaygan, Nancy
Created: 2018-05-16 10:24:51 EDT
Rev: 1
Printed By: Kuzmich, Bob
Int: 1.5
Date:May 29, 2018
