42
Accessing the SmartWare Command Line Interface
Step 5
Proceed with logging in
6.5 Accessing via a Telnet Session
This is the most usual method to connect to a SmartNode. The Telnet host accesses the SmartNode
via its network interface. A host can be connected directly to the ETH 1 port (LAN) with a crossover
cable (see Figure 6-2 A) or through an Ethernet hub with two straight cables (see Figure 6-2 B).
Note
: If the IP configuration of the Ethernet port (LAN port) is not known or is wrongly configured
you must use the console interface.
Figure 6-2: Setup For Initial Configuration via an Ethernet Port
The host must have a valid IP address configured in the same subnet as the SmartNode. Table 6-1
shows the default IP address and netmask of the Ethernet ports of the SmartNode.
Port
IP Address
Network Mask
ETH 0
10.0.0.10
255.255.0.0 / 16
ETH 1
10.1.0.10
255.255.0.0 / 16
Table 6-1: Default IP Address Configuration
Note:
The default IP addresses listed in Table 6-1 apply for a particular factory configuration, but
under certain conditions your SmartNode can have different default IP addresses. Check the
SmartWare release note for more details.
Software Configuration Guide, Revision 1.03
Summary of Contents for SmartWare R2.00
Page 2: ......
