CS Interface Configuration
197
SN(ctx-cs)[switch]#
21.5 Configure Digit Collection
The SmartWare CS context supports overlap dialling on all interfaces. Some of the connected devices
(PBX, ISDN network, remote gateways and gatekeepers) may however require bloc sending of the
dialed number. SmartWare offers three options to collect overlap dialed digits and forward them in a
single call setup message. Digit collection is applied to call setups going out from the interface to the
port or gateway as illustrated in Figure 21-2.
Figure 21-2: Digit Collection in a H.323 / ISoIP Interface
Collected overlap dialed digits are sent providing that they comply with one or a combination of
three criteria: elapse a specific timeout, receive a specific character or receive a specified number of
dialed digits.
Procedure
To configure the digit collection
Mode
Interface below Context CS
Command
Purpose
Step 1
node
(
if- type
)[
if-name
]#digit-
collection timout
seconds
Specify the timeout to wait for the first dialed or
between two dialed digits before all previous
digits are sent.
Step 2
node
(
if- type
) [
if-name
]#digit-
collection terminating-char
character
Specify a character that indicates the end of the
dialled digits # or *
Step 3
node
(
if- type
) [
if-name
]#digit-
collection nr-length
length
Specify a number of digits to collect
Software Configuration Guide, Revision 1.03
Summary of Contents for SmartWare R2.00
Page 2: ......
