Inalp Networks SmartWare R2.00, Software Configuration Manual

Page: 12 / 321

12 About This Guide
ABOUT THIS GUIDE
Objectives
The objective of SmartWare Software Configuration Guide is to provide information concerning the
software configuration and setting into service of SmartNode devices and their interface cards. The
aim is to enable you to install such devices, alone or under supervision.
For detailed descriptions of the commands in the SmartWare Revision 2.00 command set, see the
SmartWare
Command ReferenceGuide .
For hardware configuration information refer to the SmartNode Hardware Installation Guide.
Audience
The guide is intended primarily for the following audiences:
•
Technical staff who are familiar with electronic circuitry, networking theory and have
experience as an electronic or electromechanical technician.
•
System administrators with a basic networking background and experience, but who might
not be familiar with the SmartNode.
•
System administrators who are responsible for installing and configuring networking
equipment and who are familiar with the SmartNode.
Document Conventions
Inalp documentation uses the conventions listed in the Table 1-1 through Table 1-3 below to express
instructions and information.
Notice Description
Note Helpful suggestions or references to materials not contained in this
manual.
Warning Situation that could cause bodily injury, or equipment damage or data
loss
Caution Situation that could put equipment or data at risk
Table 1-1: Notice Conventions
Command Description
boldface Commands and keywords are in boldface font.
boldface italic Parts of commands, which are related to elements already named by the
user, are in
boldface italic font.
node The leading IP address or nodename of a SmartNode is substituted with
node in boldface italic font.
italic Variables for which you supply values are in italic font
Software Configuration Guide, Revision 1.03