Page | 88
11.11 Analog Inputs
NOTE:
for details on how to use
i
³ Config to configure the digital
filtering.
The analog inputs on the
i
³C Lite allow current measurement from a variety of devices.
The analog inputs have a digital filter that can be used to filter electrical noise that may be unavoidable
in some installations. The downside to digital filtering is the inputs will respond more slowly to sudden
changes in the actual input.
11.12 Analog Outputs
NOTE
for high-speed I/O information and refer to the datasheet for
i
³C Lite model.
The analog outputs on
i
³C Lite devices provide high resolution current outputs.
NOTE
: Each channel can be separately configured for voltage or current mode.
When the controller is stopped, the operation of each output is configurable. The outputs can hold
the state they were in before the controller stopped or they can go to a predetermined value. By
default, analog outputs are set to a value of zero (0). For more information on Stop State, see
Summary of Contents for i3C Lite
