IMC CAEMAX DX, Manual

Page: 67 / 92

D
x
Telemetry System
Manual Vers. 2.7
67
/
92
6 Installation
6.1 General Information

The transducer (sensor), the DX -SCT and the transformer winding should be mounted
close to each other.

In order to obtain accurate measurement results, the connection wires between sensor
and SCT have to be twisted in pairs, the signal lines In+ twisted with In- and the sensor
supply 5 V twisted with GND. Make sure
no sensor cables intersect with the
connection cables .

The mounting holes of the SCTs are for fixing only. They may be tightened with a
maximum torque of 32 Ncm.

Assembly expertise of the measuring transducer (strain gauge, thermo couple) is
assumed. Therefore, this procedure will not be discussed any further.
6.2 Safety Instructions

Do not use damaged or defective cables!

Do not touch the rotating shaft!

Do not reach into the gap between the shaft and the stator while running!

Avoid any contact with the rotor contacts while operating!

Avoid close contact of the stator with data mediums or other devices and systems to be
protected from magnetic fields.

Telemetry systems consist of electrostatic sensitive components. Operation only by
qualified personnel!

This is a class A device, i.e. suited for industrial use. This device may cause radio
interference in the living area; in this case the operator can be required to carry into effect
adequate measures and pay for them.

Temperatures above 80°C may lead to damage or breakdown of the stator. Therefore,
ensure dissipation of thermal energy caused by operation of the stator, e.g. by installing it
on a metallic surface.
6.3 Installation of the RCI

Connect the RCI to a power source. Therefore, use the DC input (9
… 36V/DC) or
connect it to the line voltage with the included power cable.

If the D
X
is to be configured with your computer, connect the Ethernet interfaces of PC
and RCI with the included Ethernet cable.

For data transmission via CAN, connect a CAN cable (CAN1: CAN output; CAN2: CAN
input).
Please note: The RCI has no built-in termination resistor. If the device is placed at the
end of a CAN measurement chain, a
120 Ω termination resistor has to be placed
between the two connectors.

For analog measurement data, connect the BNC cable to the analog outputs of the RCI.
These are freely assignable to all measurement data channels (for configuration see
section 3.8).