D
x
Telemetry System
Manual Vers. 2.7
24
/
92
When operating only one SCT, assign it to
Logical Number
1. The SCT may now use the
whole transmission window (sections 1-4).
When operating two SCTs, assign the first SCT to
Logical Number
1, the second to
Logical
Number
3. Through this configuration, each SCT uses 2/4 of transmission time.
When operating 3 or 4 SCTs, any logical number can be assigned.
When configuring with a web browser, keep in mind to confirm your input with the
Set
button
to resume it to the D
X
.
Now click on the
Program
button.
Confirm the
Program done! Repower transmitter!
message with
OK.
Figure 15: Message
Program done!
Please note:
The message
Program done!
only indicates that the configuration data has
been transmitted. For successful programming, make sure the SCT is switched on and the
RCI’s radio signal can be received by the device (ideal RCI-SCT distance for programming:
< 0.5m).
Disconnect the SCT from power supply for approx. 5 seconds, and then repower the device.
With
Devices →Device X,
open the SCT you have just programmed. Click
Search
.
If the SCT settings are found within the
Logical Number
you have recently programmed, the
configuration has been successful.
Please note:
After adding a new SCT, the channels of each SCT in the system have to be
reprogrammed (
Channels → Device X → Channel_X_Y
, see section 3.6.2).
