D
x
Telemetry System
Manual Vers. 2.7
25
/
92
3.6
Channel Configuration
After you have added one or more SCTs to your telemetry system, the corresponding
channels have to be created and programmed.
3.6.1 Generate a New Channel
Connect the sensors to the D
X
(see connecting diagram in section 2.2).
Open
Channels
→ Modes.
Now select the measuring mode for the corresponding channel
with the following options:
-
Full bridge (strain gauges)
-
Half bridge (strain gauges) with integrated bridge completion
-
DC differential
-
DC single ended
-
Thermo differential
-
Thermo single ended
Channels 7 and 8 detect reference temperature and supply voltage. These are sampled at a
rate of 25 Hz and do not charge the bandwidth.
Figure 16: Channel modes
Please note:
Due to technical restrictions, it is not possible to assign all measuring modes to
any channel. Particularly, when using one channel as full bridge or in differential mode, the
following channel is automatically blocked as sensor input. For further information, please
see section 2.2.
Confirm with
OK
or
Set.
