D
x
Telemetry System
Manual Vers. 2.7
53
/
92
4.2.9 Menu: CAN-Setup
Message x
Id:
Enter the desired CAN-ID of the message in decimal or
hexadecimal.
hex:
Switch the CAN-Id between decimal and hexadecimal.
active:
Activate the message. The message will be sent via the CAN only if
this box has been ticked. It will also be stored in the DBC-file even if
it was not activated.
Message Length:
Data:
A message has a maximum of 8 bytes, but it can be reduced if, for
example, only two channels should be transmitted. The setting is 4
bytes.
Note: For four channels, it is more convenient to transmit these in
an 8-byte CAN message since this causes less data load on the
CAN bus.
Bit-Offset:
Indicated the starting point of the 16 data bits of the respective
channel.
Sign:
Specifies whether the data should be transmitted with or without
plus/minus sign (disabled = without / active = with sign).
Mot:
Specifies the data format (unchecked = INTEL / checked =
MOTOROLA).
Delete:
Delete this message.
OK:
Exit menu.
Please note: In order to change settings permanently, you have to record your current
configuration with the
Save
button in the menu
Load/Save
4.2.10 Menu: CAN-Setup
New Msg.
If you want to use more than one CAN message, with 4 channels each, further messages
can be created. With the menu command "CAN-Setup
New Msg." You can simply add a
new message.
