D
x
Telemetry System
Manual Vers. 2.7
62
/
92
Figure 33: copper tube with holes
Please note:
The lower the distance between the primary coil and the secondary coil,
the better the efficiency of the energy transfer. However, when installing take into
account the height of the secondary coil and insulation layer, as well as any possible
movements and unbalances to the shaft
.
Install the secondary coil to the axle as described in section 6.5.2. The transmission
coil is to be installed directly beneath the primary coil.
Install the D
X
transmitter unit (SCT) to the axle and connect it. The connection strands
of the secondary coil have to be connected with the SCT inputs IP1 and IP2 (refer to
section 2.2).
Fix the stator ring with two M5x6 bolts to the stator housing. To guarantee a
maximum contact area for electron transfer, make sure the contact areas at the
copper ring are absolutely smooth and bare (remove edges and oxide film!) and
tighten the connection screws properly (refer to Figure 34).
Important:
Use the potentiometer screw on the stator housing to set its power to
minimum value. The direction of rotation for decreasing the stator power is indicated
on the housing. When the potentiometer screw has reached its minimum position,
you will hear a click sound even though you can turn it further.
