D
x
Telemetry System
Manual Vers. 2.7
55
/
92
4.2.13 Menu: Measure
Start
1:
Indicates which display you are using. You can switch between
displays by pressing up and down on the scrollwheel.
dbm display:
An indicator shows the signal strength as decimal or bar graph.
Display type can be chosen in “Options
RF-Level Display in
dbm”.
Autozero:
When this button is pressed, all channels for which "Autozero" has
been selected are set to zero. If the adjustment is to be permanently
stored in the SCT, the corresponding channel must be programmed
afterwards (“Channels
Channel x
Program”).
Sh. off / Sh. on
By pressing this button, the internal shunt resistor will be connected
between “signal-plus” and “bridge supply-plus”. This results in a
positive oscillation of the signal. If the shunt is activated this is
indicated by the changed button label to “Sh. on”. The shunt
resistance is 330 kΩ.
Cancel:
Exit measurement mode.
IMPORTANT: The CAN-output is only active in measurement mode.
