D
x
Telemetry System
Manual Vers. 2.7
32
/
92
3.6.5 Configure Thermocouples (differential or single ended)
Open the desired channel by selecting
Channels
→ Channel X.
3.6.5.1 Calibration
In the
Calibration
section, enter a two-point calibration line in the
Sample 1
and
Sample 2
fields
.
Define physical unit of output in the
Units
field.
3.6.5.2 Measurement Range
Enter upper and lower bound of desired measurement range in the fields
Range min:
and
Range max.
The measurement range resolution is 16 bits.
Please note:
The measurement range can be increased/decreased by powers of two and is
centered on zero.
3.6.5.3 Thermo mode
Select type of thermocouple (type J or type K).
When configuring with a web browser, confirm your input with the
Set
button to resume it to
the D
X
.
Select
Program
.
Please note:
Make sure the SCT is switched on (i.e. supplied with power) and radio
transmission from RCI to SCT is undisturbed. Otherwise, the SCT can’t be programmed
successfully.
Confirm the message
.
Figure 21: Temperature channel configuration
