Illustra Flex Series Installation and Configuration Guide
44
8200-1456-01 D0
Clear
Enable DHCP
to disable DHCP and allow manual settings to be entered.
The default setting is ‘Enabled’.
4
If Enable DHCP has been disabled:
a
Enter the
IPv4 Address
in the IPv4 Address text box in the form xxx.xxx.xxx.xxx.
The default setting is ‘192.168.1.168’
b
Enter the
Network Mask
in the Network Mask text box xxx.xxx.xxx.xxx.
The default setting is ‘255.255.255.0’
c
Enter the
Gateway
IP address in Gateway text box xxx.xxx.xxx.xxx.
d
Enter the
Primary DNS Server
in the Primary DNS Server text box xxx.xxx.xxx.xxx.
5
Select
Apply
to save the settings.
- End -
IPv6
Enable or disable IPv6 on the camera.
Procedure 33 Enable/Disable IPv6
Step Action
1
Select
Setup
on the Web User Interface banner to display the setup menus.
2
Select the
TCP/IP
tab in the
Basic Configuration
menu.
3
Select the
IPv6 Enable
check box to enable IPv6 on the camera.
OR
Clear the
IPv6 Enable
check box to disable IPv6 on the camera.
The default setting is ‘Enabled’.
If IPv6 is enabled the Link Local and DHCP address display beside ‘Current IPv6
Addresses’ if available.
- End -
Video Stream Settings
You can configure three video streams on the camera: Stream 1, Stream 2, and Stream 3.
Configuring the Web Video Stream
Adjust the settings for each video stream.
Procedure 34 Configure the Video Stream settings
Step Action
1
Select
Setup
on the Web User Interface banner to display the setup menus.
2
Select the
Streams
tab in the
Basic Configuration
menu.
3
Select either
Stream 1
,
2
or
3
from the
Stream Number
drop-down menu.
4
Select the required
Codec
from the drop-down list:
• H264
