Illusonic IAP8, Owner'S Manual

Page: 54 / 64

52 Illusonic IAP 8 Chapter 9
Menu: System
MEASUREMENT
OFF
Here you can select a loudspeaker channel which
will be used to reproduce the left channel of the se-
lected input source.
1
Typically, this menu is used for:
– Checking if your loudspeakers are connected
to the correct IAP 8 output channels.
– Measurement of your loudspeaker system
without disconnecting the loudspeakers
from the Processor.
When you exit this menu, it will be set automatically
to Off.
1 Gain/delay trim, equalizers, and bass management
are applied depending on whether they are switched
on or off in the currently active preset (Chapter 3.4).
FIRMWARE VERSION
DSP
1.00
This menu shows the versions of the various
firmwares of IAP 8.
NETWORK
MAC ADDRESS
02 80 AD 23 01 76
NETWORK
IP ADDRESS
192.168.1.2
In this menu, IAP 8’s network IP and MAC
addresses are shown.
STANDBY LED
BRIGHTNESS
||||||||||||||||
In this menu, you can adjust the brightness of the
front panel LED during standby.
2 Note that all settings of the Processor are
overwritten with default settings. Do not use this
function, unless you plan to re-configure all parameters.
FACTORY DEFAULT
ARE YOU SURE?
YES (SELECT)
To set IAP 8 to its factory default settings, choose
“Yes (Select)” and push Select (Rotary Push) .
2