Ikegami HDK-790GX, Operation Manual

Page: 88 / 136

76
HDK-790GX 1403 VER1 (U)
5.2 Settings from the Menu
---
FILE SET
FILE SET creates a lens
¿
le.
To change the settings, select “LENS SELECT” on MENU (3/4), then “FILE SET” .
The following explains the set values, descriptions, and setting procedures.
Set Value Description
OFF (default) Does not create lens files.
MANUAL Stores the current lens status as a file. (“LENS No. x” will be displayed at the bottom of the screen.)
AUTO Starts auto setup for lens file creation. (“PUSH SET -> START” will be displayed and flash at the bottom of the screen.)
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Light
Light
Camera
Tripod
Picture monitor
(connect if required)
Illumination
meter
MON SDI OUT connector
Coax cable
WFM
Note:
- The creation of lens
¿
le requires precise adjustment; therefore, lens
¿
les are protected against unintentional update by the S11-4 DIP
switch of the MPU module.
- When creating a lens
¿
le, set the optical
¿
lter to ND:100% and the ECC
¿
lter to 3200K. Also con
¿
rm that no special effect
¿
lter is
attached to the front of the lens or internal
¿
lter disk. If a special effect
¿
lter is attached, it may not be possible to correctly create the
lens
¿
le.
- When operating the DIP switch (S11) in the MPU module, turn the POWER switch of the camera OFF once.
1
Set the camera for level setup.
- Mount the standard lens, which is used as a reference lens, to the camera.
- Chart on which Kent paper, etc. has been pasted and the entire surface is uniform white is used for the photographic
subject.
- Use an illumination meter to adjust the light so that light is evenly distributed over the whole chart.
2
Dip switch S11-4 On allows creation of a lens fi le, Off prohibits creation of new lens fi les.