Ikegami HDK-790GX, Operation Manual

Page: 67 / 136

OPERA
TION
4
55
HDK-790GX 1403 VER1 (U)
4.5 Output Signal Check
4.5 Output Signal Check
After turning ON the power, ensure that signals are correctly output on the PM and WFM. If the signals are not output for some
reason, check the following before concluding that there is a failure.
- Are the cables properly connected ?
- Are the switches correctly set ?
- Is the breaker thrown ?
- Is the POWER switch set to ON ?
Reference:
See “3. INSTALLATION and CONNECTION” for connection of peripheral equipment.
Color-Bar Signal Check
1
Set the BARS button on the OCP or MCP to ON.
Ensure that a normal color-bar signal is output.
To output color-bar signals to the monitor system, operate the MONITOR SELECT button.
R G B Y SEQ
MIX
SUP
100%
80%
60%
40%
20%
0%
-20%
100%
80%
60%
40%
20%
0%
-20%
R G B SEQ Y ENC
Super
/Mix
WFM/PM
O C P - 2 0 0
CAM PWR VF PWR
STANDARD
INFO OPE SETUP
SCENE FILE
GAIN
PED / FLARE
M FLARE
KNOB
FREE
HEAD POWER
OPT
CABLE
DTL GAMMA
KNEE PT SLOPE
SHIFT NEXT
FLARE
CONT
MAINTE USER WFM/PM
W U M S O I
TALLY AWB ABB
CAP BARS CAL AWB ABB
PM IND
/ PAGE
PANEL
ENABLE
OFF
1 2 3 4
5 6 7 8
HEAD CCU
OPEN SHORT
ALARM CALL
PED
PREVIEW
FULL RELATIVE
LENS EXT
AUTO
IRIS
RANGE SENS
CLS OPEN ±1 ±2
MCP
OCP
BARS button
"ON"
BARS button
"ON"
MONITOR SELECT button
"ENC" button
LCD panel
MONITOR
SELECT button
"Y"
[SDTV]
[ HDTV ]
PM
WFM
PM
WFM
Note:
When no color bar signal is not displayed on the SDTV signal while you use MCP-200 and press the “Y” button of the MONITOR
SELECT buttons, refer to the operation manual for MCP-200.