IFM ecomat 100 R 360 Series, System Manual

Page: 84 / 166

page 84
Function outputs
Description The function SLAVE_8_CONFIG sets or reads the I/O
configuration parameters of the 8-channel modules from ifm.
The requested configuration is set with the parameters. To
check the execution of the function the inputs READ or WRITE
should remain set until the function output CFG_RESULT has
the value 1. If the data have not yet been updated or if they
cannot be read or written, the function output CFG_RESULT
has the value 0.
The parameters can be assigned to the function during the run
time of the application program. A function block is not
necessary for each node.
The configuration data for the I/O module only become active in
the state "pre-operational". If the configuration is performed in
the state "operational", the new settings do not become valid
before passing into the mode "pre-operational" -> "operational".
Name Data type Description
CFG_RESULT BYTE 1 = The configuration has been read
or written successfully.
2 = The configuration has not yet
been read or written.
CHANNEL_1_ BYTE Current configuration parameters for
channel 1
CHANNEL_2_ BYTE Current configuration parameters for
channel 2
CHANNEL_3_ BYTE Current configuration parameters for
channel 3
CHANNEL_4_ BYTE Current configuration parameters for
channel 4
CHANNEL_5_ BYTE Current configuration parameters for
channel 5
CHANNEL_6_ BYTE Current configuration parameters for
channel 6
CHANNEL_7_ BYTE Current configuration parameters for
channel 7
CHANNEL_8_ BYTE Current configuration parameters for
channel 8