IDS X Series Training V2.3 | Partition Options
33
Location 211 to 218: Partition Configuration
Location Type: Bitmap
These options are to set how the system must behave when the partition needs to be armed.
LED Default Action
Description
1
OFF
Instant Arm
Instant arm allows the alarm to arm without an exit delay
2
ON
Instant Key-switch arm
When using a zone to arm or disarm this will enable or
disable the
alarm to arm without an exit delayexit delay
3
ON
Quick Arm Key
This is to enable/disable the pressing of the 1 key to
start the arm cycle instead of inserting a user code
4
ON
Quick Stay Arm Key
This is to enable/disable the pressing of the 5 key to stay
arm
5
ON
Auto Stay Arm if No Exit Zone is
Triggered
When arming with a user code and no entry/exit zone is
triggered then the alarm will automatically arm in stay
mode
6
OFF
Auto Stay Arm if No Exit Zone is
Triggered When Arming with a Key-
switch
When arming
with a remote transmitterusing an
arm/disarm zone
and no entry/exit zone is triggered then
the alarm will automatically arm in stay mode
7
OFF
Disable
Forced Arm
ing
This will bypass any triggered zone allowing the system
to be armed even though there are triggered zones
8
ON
Zone Bypassing
This enables or disables the ability for a user to bypass
faulty zones using the 9 key.
9
OFF
Arm with Zones in the Entry Route
Violated
This allows movement to take place in a follower zone
and the entry / exit zone to be violated when you are
about to arm
10
OFF
Siren Toot on Arm
When the alarm arms in the away mode the siren will
give one toot to indicate that it has armed
11
OFF
Siren Toot on Disarm
When the alarm disarms from being away armed it will
toot twice
12
ON
Entry Beep
This will silence the keypad when the entry zone is
triggered to start the entry cycle
13
ON
Exit Beep
This will silence the keypad when the alarm starts to arm
14
OFF
Engineer's Reset
This option will lock the alarm system, until the installers
code has been entered, when an alarm has occurred.
15
OFF
Auto Disarm
When enabled the alarm will automatically disarm and
the time set in locations 189
16
OFF
Open & Close Reporting
This is a global enable or disable of opening &
closing user reporting. By default all users are
enabled by default. Enabling this option and all
user codes will begin reporting opens and closes
Exercise:
Let us enable siren toot on arm and disarm so the customer will know if the alarm is armed when
using a remote transmitter.
Instructions
Keypad presses
Enter the partitions location
[2][1][1] [*]
Option 10 and 11 need to be enabled
[1][0] [*] [1][1] [*]
Exit the location
[#]
