Auto Sentry®
flex
User Manual
103
Service Unit Screen
Open Terminal
Select the
Open Terminal
button or use the override switch if installed at the facility.
Diagnostics
The diagnostics screen displays information about the bill dispenser. You can also test the printer
and issue a dispense command to the bill dispenser and coin hoppers.
Table 1: Diagnostics Screen Icon Descriptions
Tap the
Test
button to print a test receipt.
Tap the bill dispenser, coin, or token hopper,
and then tap the
Dispense
button. A single
bill or coin is ejected from the device. This is
not recorded in the software. You should
replace the bill or coin after it has been
dispensed.
Tap the
Refresh
button to redisplay the
dispenser diagnostics. This will take another
reading of all the sensors and display the
health again.
Tap the
Exit
button to leave the diagnostics
screen.
Tap the
Clear Memory
button
(
DeLaRue
®
bill
dispensers only). Clears bill calibration
settings. Unit will need to be reprogrammed
to learn bills.
Tap the
Lock
button (
DeLaRue
bill dispensers
only). Physically locks the cassette so it
cannot be removed.
Summary of Contents for Auto Sentry flex
