2-4
2
2.6
USING ICS'S GPIBKYBD PROGRAM
This section describes how to use ICS's GPIBkybd Program to configure a
unit.
1.
First install the GPIBkybd program on your computer by browsing
the CD and going to the GPIBkybd Folder. Double click on the
ICS_GPIBkybd_Install program to run it. Accept the defaults to
install the program on your C Drive.
2.
Connect the 4807 to the GPIB controller card in the PC with a GPIB
Connector/Address Switch Board as shown in Figure 2-1. Use a
DC Power Supply to p 5 Vdc to the test points or at the
power pins on J3.
or
Connect the 4867 directly to the GPIB controller card in the PC as
shown in Figure 2-2. Use the included AC power adapter to power
the 4867.
4807
PC Computer
DC Power Supply
5 Vdc
GPIB Conn/
Addr Sw Assy
Figure 2-1 4807 Configuration Setup
