ICON500 high performance vector control frequency inverter user
manual
Chapter 4 Operation and
display
- 24
-
ESC
ENTER
ESC
ENTER
ESC
ENTER
ESC
ENTER
PARAMETER
EDIT/VIEW
STATUS
9
Indicator light:Hz
·
Indicate the digital display unit, all three lights off
menas other units
10
Indicator light:A
11
Indicator light:V
12
Running lights
• Off: indicates a stop condition.
• On: indicates inverter is
running.· Blinking: Deceleration
stopped.
13
Direction indicator
• Used to indicate the sign of the variable when the LED is
displaying one of the variables listed in 27.02;
• In other cases the sign of the output frequency is indicated.
14
Command source
indicator
• Off: The command source is the keyboard.
• On: The command source is terminal.
• Blinking: The command source is communication.
15
Fault indicator
• When it is on, the drive is faulty.
Display hierarchy and menu mode
ICON500 digital keyboard display is divided into four layers, from top to bottom are: monitoring status, menu
mode selection status, function code selection status, parameter editing / viewing status, as shown in Figure 4-2. In
the menu mode selection status, press
【
UP
】
or
【
DOWN
】
key to select menu mode, press
【
ENTER
】
to
enter the selected menu mode, the following describes several menu modes:
MONITO
R
STATUS
Monitoring volume1
Monitoring volume2
Monitoring volume3
Monitoring volume4
ESC
SHIF
T
Monitoring
volume1
MENU
CHOOSE
STATE
UP
UP
UP
UP
“
-bSC-
”
Standard mode
DOWN
User-difined mode
DOWN
Check mode
DOWN
Wizard mode
DOWN
ESC
ENTER
ESC
ENTER
ESC
ENTER
ESC
ENTER
COMMAND
CODE
【
UP
、
DOWN
、
SHIFT
】
【
UP
、
DOWN
】
【
UP
、
DOWN
】
【
UP
、
DOWN
】
【
UP
、
DOWN
、
SHIFT
】
【
UP
、
DOWN
、
SHIFT
】
【
UP
、
DOWN
、
SHIFT
】
【
UP
、
DOWN
、
SHIFT
】
Standard mode
（
-bSC-
）
Keyboard operation diagram
If visiting access (P00.01) is standard, all the function codes mentioned in this manual are accessible.
If visiting access (P00.01) is the end user (in the state of user password lock), then only some function code can be
accessed.
User-difined mode
（
-USr-
）
In this menu mode, only 20 user-defined parameters defined are displayed.
SHIF
T
SHIF
T
SHIF
T
ES
C
