8-3
BASIC MANUAL
SET MODE
8
8
FM/DV Center Error
(Default: ON)
Turns the FM/DV Center Error indication ON or OFF.
The RX indicator shows the received signal deviation.
When an off-center signal is received, the indicator
blinks green.
•
OFF: Turns OFF the function.
• ON: Turns ON the function.
Auto Power OFF
(Default: OFF)
Selects whether or not to automatically turn OFF the
transceiver after inactivity for this set period of time.
L
“AUTO POWER OFF” is displayed and beeps sound
5 seconds before turning OFF the transceiver. If you
operate the transceiver during this period of time, the
Auto Power OFF timer is reset.
•
OFF: Does not turn OFF the transceiver.
• 30/60/90/120min:
Turns OFF the transceiver after inactivity for
this set period of time.
»
SET > Function >
TX Delay
144M
(Default: OFF)
430M
(Default: OFF)
1200M
(Default: OFF)
2400M
(Default: OFF)
5600M
(Default: OFF)
10G
(Default: OFF)
Sets the TX delay time on each band.
L
If an external equipment’s rise time is slower than that
of the IC-905, a reflected wave is produced, and it may
damage the IC-905 or the external device. To prevent
this, set the appropriate delay time so that no reflected
wave or timing damage occurs.
L
Select “OFF” for no delay.
SEND
Po
Rx
Tx
0
10
Delay time (ms)
» SET >
Function
Time-Out Timer
(Default: 10min)
Sets the Time-out Timer to OFF, 3, 5, 10, 20, or
30 minutes to prevent an accidental prolonged
transmission.
L
Select “OFF” for no time limit.
PTT Lock
(Default: OFF)
Turns the PTT Lock function ON or OFF. To prevent
accidental transmissions, this function inhibits all
transmissions.
•
OFF: Turns OFF the function.
• ON: Inhibits all transmissions.
»
SET > Function >
SPLIT
Quick SPLIT
(Default: ON)
Turns the Quick SPLIT function ON or OFF.
This function automatically turns ON the SPLIT
function, and sets the frequency and mode to the VFO
that is not displayed (VFO A or AFO B), according to
the SPLIT Offset setting.
•
OFF: Turns OFF the function.
• ON: Turns ON the function.
SPLIT Offset
(Default: 0.000 MHz)
Sets the SPLIT offset between –9.999 and +9.999 MHz.
The SPLIT offset is the difference between the receive
and transmit frequencies for the Quick SPLIT function.
SPLIT LOCK
(Default: OFF)
Turns the Split Lock function ON or OFF.
The SPLIT LOCK function enables you to adjust the
transmit frequency while holding down
, even
while the Dial Lock function is activated. To prevent
accidentally changing the receive frequency by
rotating
, use both the SPLIT LOCK and
•
OFF: Turns OFF the function.
• ON: Turns ON the function.
