32
6
SCAN
Repeater search scan
■
The Repeater search scan is used not only to search for a
signal on the repeater channels, but also to access a repeat-
er by automatically transmitting in sequence. The repeater
search function searches available repeaters in the area,
even if the repeater is not in use.
The Repeater search scan detects signals only on the Channels
1 to 8 and Channels 41 to 48 channels. Therefore, repeater avail-
ability cannot be guaranteed even if the repeater scan is stopped,
because the scan will stop if any activity is detected. The scan is
cancelled when receiving a signal, such as stations communicating
in Simplex operation on a repeater output channel.
*Excludes Emergency Repeater ‘RPT-05.’
Select the desired repeater output channel (‘RPT-01’ to
q
‘RPT-08’ and ‘RPT-41’ to ‘RPT-48’), and hold down
O
G
P
RS
(Rpt
Scan) for 2 seconds to start the Repeater search scan.
• See the fl ow to the details.
w
When receiving a signal on the repeater channel, the scan
stops.
• During second cycle scanning, 3 high beeps sound when receiv-
ing a signal, and 3 low beeps sound when no signal is received.
Push
e
O
G
P
RS
(Scan Mode) to manually cancel the Scan.
• During transmission, the repeater scan cannot be cancelled.
Repeater search scan
D
Appears
Appears
Scan
Scan
Searches for sig-
nal on the repeater
output channels.
Automatically access
the repeater .
(0.5 seconds)
Wait for a signal from
the repeater.
(0.5 seconds)
Automatically access the
next repeater.
(When no reply signal is received.)
Scan is automatically cancelled.
Scan start
channel
NOTE:
Excludes Emergency Repeater ‘RPT-05.’
Summary of Contents for IC-440N
Page 1: ...INSTRUCTION MANUAL i440N UHF TRANSCEIVER ...
Page 56: ...Cut here ...
Page 59: ...MEMO Cut here ...
Page 60: ...MEMO ...
