Icom IC-440N, Instruction Manual

Page: 20 / 64

14
3
BASIC OPERATION
Turning power ON
■
Hold down
q
for 2 seconds to turn ON the power.
If the transceiver is programmed with a start-up password,
w
this needs to be entered before the transceiver can be op-
erated.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block, as identical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
MONI F
SET T SQL
PRIO
LOW
SCAN
O
࡮
G
࡮
P
CH
SET ࡮ P
RS
TAG
SQL
[PWR]
O ࡮ G ࡮ P
RS
SCAN
TAG
PRIO
SET ࡮ P
LOW
O ࡮ G ࡮ P
RS
SCAN
TAG
PRIO
SET
࡮
P
LOW
e
When the “PASWD” indication does not clear after input-
ting 4 digits, the input number may be incorrect. Turn OFF
the power and start over from step
q
.
If the input number is not as you disired, also start over
from step
q
.
Volume
■
➥
Push or to select the desired volume level.
• “ ” appears when volume level 0 is selected (while the internal
speaker is muted).
Channel
■
➥
Push CH
SQL
to enter the channel selection mode, then push
or to select the desired channel.
• Holding down or , the displayed channel changes con-
tinuously until channel 1 is selected.
• When channel 1 is selected, beeps sound.
• ‘CB-XX’ appears when the CB channel is selected, and ‘RPT-XX’
appears when the RX channel is selected.
• “ ” appears when you select the channel selection mode.
Appears