IBM xSeries 260, User Manual

Page: 218 / 312

Step 14
The diagnostics produced an SRN for this problem.
1. Record the SRN and other numbers read out.
2. Report the SRN to the service organization.
3. STOP. You have completed these procedures.
Step 15
When you are loading the Stand-alone Diagnostics, the attributes for the terminal
must be set to match the defaults of the diagnostic programs. The ASCII terminal
must be attached to serial port 1 on the system unit.
Are you going to load Stand-alone Diagnostics and run them from a ASCII
terminal?
NO Go to “Step 16” on page 8-9.
YES Go to “Running the Diagnostics from a tty Terminal” on page 5-3. and be
sure your terminal attributes are set to work with the diagnostic programs.
Return to “Step 16” on page 8-9 when you finish checking the attributes.
Record any settings that are changed.
8-8
User's Guide