IBM xSeries 260, User Manual

Page: 175 / 312

Configure Remote Maintenance Policy
The Remote Maintenance Policy includes modem configurations and phone numbers
to use for remote maintenance support.
Use this service aid to display and change the following settings for the Remote
Maintenance Policy.
Note: Because of system capability, some of the following settings may not be
displayed by this service aid.
Ÿ
Configuration File for Modem on S1
Configuration File for Modem on S2
Enter the name of a modem configuration file to load on either serial port 1 (S1)
or serial port 2 (S2). The modem configuration files are located in the directory
/usr/share/modems. If a modem file is already loaded, it is showed by 'Modem
file currently loaded'.
Ÿ
Modem file currently loaded on S1
Modem file currently loaded on S2
This is the name of the file that is currently loaded on serial port 1 or
serial port 2.
Note: These settings are only shown when a modem file is loaded for a
serial port.
Ÿ
Call In Authorized on S1 (on/off)
Call In Authorized on S2 (on/off)
Call In allows the Service Processor to receive a call from a remote terminal.
Ÿ
Call Out Authorized on S1 (on/off)
Call Out Authorized on S2 (on/off)
Call Out allows the Service Processor to place calls for maintenance.
Ÿ
S1 Line Speed
S2 Line Speed
A list of line speeds is available by using 'List' on the screen.
Ÿ
Service Center Phone Number
This is the number of the service center computer. The service center usually
includes a computer that takes calls from systems with call-out capability. This
computer is referred to as "the catcher". The catcher expects messages in a
specific format to which the Service Processor conforms. For more information
Chapter 6. Introduction to Diagnostic Tasks and Service Aids
6-9