Avoiding Hardware Conflicts
3
Select the Network icon.
A window appears at the bottom of the screen for you to select
the RPL speed.
4
If you are using a token-ring card, select 4 (4Mbps) or 16
(16Mbps) for the RPL speed.
If you are using a network card other than a token-ring card,
you can select either RPL speed.
5
Click on OK or press Enter; then restart the computer.
Starting the Computer from an ATA PC Card
To start the computer from an ATA PC Card:
1
Using the PS2 command or ThinkPad Features program,
check that there is no conflict between the system
resources used by the PC Card and by other devices.
The following is the system resources for an ATA card:
IRQ
15
I/O Address (HEX)
0170–0177
IRQ15 is the default setting used by the UltraBay of the
computer. To start the computer from the ATA card, change
the IRQ for the UltraBay or disable it with the ThinkPad
Features program or the
IDE2
PS2 command (see page 318).
2
Start Easy-Setup and select the Start Up icon.
3
Select the PCMCIA icon.
You cannot set the PC Card (PCMCIA icon) to follow the hard
disk drive of the computer (HDD-1 icon). If the HDD-1 icon is
already in the drive-startup sequence, click on the Reset icon;
then set the sequence.
4
Click on OK or press Enter; then restart the computer.
Appendix A. Avoiding Hardware Conflicts
287
Title: C78TFMST CreationDate: 07/11/95 14:33:57
