IBM ThinkPad 380Z, User Manual

Page: 101 / 157

13
Remove the TrackPoint Driver Diskette II for Win95/98/NT from
the diskette drive, and restart your computer to make the new
settings effective.
Disabling the Unnecessary CD-ROM Device Drivers for
Windows 95
This section describes how to disable the unnecessary DOS and
Windows CD-ROM device drivers.
If you installed Windows 95 on a blank hard disk drive without
DOS and Windows, Windows 95 has automatically installed a
generic ATAPI CD-ROM device driver for your ThinkPad's
CD-ROM drive. You do not need to do the following procedure.
If you installed Windows 95 in a computer on which DOS and
Windows had been already installed, you need to disable the
DOS and Windows CD-ROM device drivers to use the correct
Windows 95 generic ATAPI CD-ROM device driver.
To disable the DOS and Windows CD-ROM device drivers:
1
Start Windows 95 and go to the MS-DOS command prompt.
2
Open the CONFIG.SYS file with your text editor; then find the
following line:
DEVICE=C:\xxxxxx\IBMTPCD.SYS /R
Note:
xxxxxx is the subdirectory where you have installed the
CD-ROM device driver. The default subdirectory for
C:\
xxxxxx is C:\CDROM.
If you cannot find the line, quit the file and go to step 4.
3
Comment out the line to change it as follows:
REM DEVICE=C:\xxxxxx\IBMTPCD.SYS /R
If the line is already commented out, quit the file and go to the
next step.
4
Open the AUTOEXEC.BAT file; then find the following line:
C:\xxxxxx\MSCDEX.EXE /D:TPCD 1 /M:15
Chapter 6. Installing Software
97