IBM System storage DS6000 Series, Attachment Manual

Page: 74 / 298

Installing the KGPSA- xx adapter card in an OpenVMS host system
This section provides the steps you must follow to install the KGPSA- xx adapter
card.
1. Shut down the Hewlett-Packard AlphaServer host system.
2. Use the procedures that are provided by the manufacturer of the adapter card
to install the KGPSA- xx host adapter.
3. Restart the host (nonclustered configurations) or each cluster member
(clustered configurations).
4. Bring each host system to a halt condition at the console level.
5. Type set mode diag at the Hewlett-Packard AlphaServer console to place the
console in diagnostic mode.
Note: This step is only for certain AlphaServer models.
6. Type
wwidmgr-show adapter
to confirm that you installed each adapter properly.
7. If necessary, update the adapter firmware.
Figure 25 shows an example of what you see when you type set mode diag
and wwidmgr -show adapter . Figure 25 shows the worldwide node name
(WWNN). You also need the worldwide port name (WWPN) to configure the
storage unit host attachment. To determine the WWPN for the KGPSA adapters,
replace the } 2 } in the WWNN with a } 1 } .
Setting the mode for the KGPSA- xx host adapter in an OpenVMS host
system
This task describes setting the mode for the KGPSA- xx host adapter for an HP
OpenVMS host system.
You must install the KGPSA- xx host adapter before you can set the mode.
The KGPSA- xx fibre-channel adapter card must be set to FABRIC. Use the
wwidmgr -show adapter console command to see the setting for the Cur. Topo
and Next Topo variables. Figure 26 on page 45 shows example output from the
wwidmgr command.
1. Type # shutdown -h now to shutdown the operating system.
P00>>> set mode diag
Console is in diagnostic mode
P00>>> wwidmgr -show adapter
polling for units on kgpsa0, slot 9, bus 0, hose0...
kgpsaa0.0.0.9.0 PGA0 WWN 2000-0000-c922-69bf
polling for units on kgpsa1, slot 10, bus 0, hose0...
kgpsab0.0.0.10.0 PGB0 WWN 2000-0000-c921-df4b
item adapter WWN Cur. Topo Next
Topo
[ 0] kgpsab0.0.0.10.0 2000-0000-c921-df4b FABRIC
FABRIC
[ 1] kgpsaa0.0.0.9.0 2000-0000-c922-69bf FABRIC
FABRIC
[9999] All of the above.
P00>>>
Figure 25. Example of the set mode diag command and the wwidmgr -show adapter
command
44
DS6000 Host Systems Attachment Guide