IBM System storage DS6000 Series, Attachment Manual

Page: 205 / 298

Table 12. Recommended configuration file parameters for the QLogic QLA2310F, QLA2340,
and QLA2342 adapters with driver level 4.03 (continued)
Parameters Recommended settings
hba0-enable or disable-target-reset =0: disabled
hba0-reset-delay =5;
hba0-port-down-retry-count =30;
hba0-link-down-error =1: enabled
hba0-loop-down-timeout =60;
hba0-connection-options
v =0: loop only (for direct attachment)
v =1: point-to-point only (for fabric
attachment)
hba0-device-configuration-mode =1: use port name
hba0-fc-tape
v =0: disabled
v =1: enabled
hba0-fc-data-rate =2: Auto-negotiate
hba0-command-completion-option =0: response queue
persistent binding only option =0: reports the discovery of persistent binded
and non-binded devices to the operating
system
Parameter settings for the QLogic QLA23 xx adapters for San Surf
configuration (4.06+ driver)
The following table provides the parameter settings for the QLogic QLA23 xx
adapters for storage units with the San Surf configuration (4.06+ driver).
Table 13 provides the QLogic QLA23 xx adapter settings for storage units with the
4.06+ driver of the San Surf configuration.
Table 13. Parameter settings for the QLogic QLA23xx host adapters for San Surf
Configuration (4.06+)
Adapter parameter Recommended settings
Host Parameters
Execution Throttle 16 (default)
Frame Length 2048
Port Down Retry Count 30
Connection Options
v Loop Only
v Loop Retreived
v
Point-to-Point
Enable Fibre Channel Tape Support Enable
Enable Fibre Channel Confirm Enable
Data Rate 2 Auto Negotiate
Advanced Host Parameters (See Note 1)
Persistent Plus New Enable
Persistent Target Only Disable
Persistent Bind HBA Disable
Chapter 18. Attaching to a Sun host
175