IBM NetVista 6058, Hardware Maintenance Manual

Page: 23 / 248

Diagnostic Error Code FRU/Action
014-013-XXX
014-014-XXX
Parallel port Control
Signal/Loopback test failure
1. System board
014-015-XXX
Parallel port External Loopback
failure
1. Wrap plug
2.
System board
014-027-XXX Parallel port Configuration/Setup
error
1. Run Setup, enable port
2. Flash the system
3.
System board
014-03X-XXX
014-04X-XXX
Parallel port failure
1. System board
014-195-XXX Parallel port Test aborted by user
1. Information
2. Re-start the test, if necessary
014-196-XXX Parallel port test halt, error
threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
014-197-XXX Parallel port test warning
1. Make sure the component that is called out is
connected and/or enabled
2.
Re-run test
3. Component that is called out in warning statement
4. Component under test
014-198-XXX Parallel port test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the
″
Undetermined problems
″
section
014-199-XXX Parallel port test failed, cause
unknown
1. Go to the
″
Undetermined problems
″
section
2. Flash the system and re-test
3.
Replace component under function test
014-2XX-XXX
014-3XX-XXX
Parallel port failure
1. External parallel device
2. System board
015-000-XXX USB port Interface Test Passed
1. No action
015-001-XXX
USB port Presence
1. Remove USB device(s) and re-test
2.
System board
015-002-XXX USB port Timeout
1. Remove USB device(s) and re-test
2. System board
Chapter 1. IBM PC Enhanced Diagnostics error codes
9