IBM NetVista 6058, Hardware Maintenance Manual

Page: 17 / 248

Diagnostic Error Code FRU/Action
001-027-XXX System Configuration/Setup error
1. Run Setup
2.
Flash the system
3. System board
001-032-XXX System Device Controller failure
1. System board
001-034-XXX System Device Buffer Allocation
failure
1. Reboot the system
2. Flash the system
3.
Run memory test
4. System board
001-035-XXX System Device Reset condition
detected
1. System board
001-036-XXX System Register error
1. System board
001-038-XXX System Extension failure
1. Adapter card
2. System board
001-039-XXX System DMI data structure error
1. Flash the system
2. System board
001-040-XXX
System IRQ failure
1. Power-off/on system and re-test
2.
System board
001-041-XXX System DMA failure
1. Power-off/on system and re-test
2. System board
001-195-XXX System Test aborted by user
1. Information
2. Re-start the test, if necessary
001-196-XXX System test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
001-197-XXX System test warning
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
001-198-XXX System test aborted
1.
If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the
″
Undetermined problems
″
section
Chapter 1. IBM PC Enhanced Diagnostics error codes
3