IBM Deskstar Deskstar 3, User Manual

Page: 58 / 392

093 EJECT PENDING
and beep the alarm. When the end of the form is reached, the printer becomes
not ready, displays:
003 FORMS EJECTED
PRESS LOAD
and advances the form so that you can tear off the form at the perforation and
remove it from the printer.
Pressing the key a second time moves the next form to be printed back to the
previous print position and makes the printer ready.
Refer to “Continuous Forms Eject Mode” on page 152 for more information on
changing Continuous Forms Eject mode.
v
Ejects forms for viewing
If a Form Feed is not done prior to pressing Load/Eject, the forms will be
positioned for you to view them to examine the printing
Rear Pull
This key is invalid when the printer is in an end-of-forms condition. The last form
is automatically ejected from the printer when an end-of-forms condition is
encountered.
There is no automatic loading for the Rear Pull paper path. When the printer
displays:
001 END OF FORMS
LOAD FORMS
Press Stop and manually align the forms on the rear tractor.
Press Load/Eject. Use the Micro
↑
or Micro
↓
to position the forms.
Push-Pull
The Push-Pull paper path uses both the front and rear tractors
v
Loading the front tractors
After the forms are loaded under the sensor and onto the tractors at the bottom
of the forms device, press Load/Eject to automatically load the forms to the top
of form position.
v
Loading the rear tractors
Manually align the forms on the rear tractor. Use the Micro
↑
or Micro
↓
to
position the forms.
v
Press Form Feed to advance the forms to the top of the next form.
Manual Sheet Feed
If Automatic Manual Load is set to
Disabled
in the Printer Setup category, the
printer displays:
004 PRESS LOAD
48
4247 Model 003 User’s Guide